The replacement necks and bodies are for a Fender® or Squier® by Fender® guitar or bass. Strat®, Stratocaster®, Esquire®, Telecaster®, Tele®, Jazzmaster®, Jaguar®, Mustang®, P.Bass®, J.Bass® and Fender® are registered trademarks of Fender® Musical Instruments. Comes with tinned leads - cut off and splice connector from original fan.
The newer style 1cm thick version, which replaces the older style 2cm thick OUTPUT MODULE FAN - Marshall® AVT SERIES AMPSįits only the Marshall® AVT50, AVT100, AVT150 and AVT275 models. Comes with 12" tinned leads - cut off and splice connector from original fan. RPM, 24.0 Cubic Feet/Minute Airflow, 33dBA Noise. OUTPUT MODULE FAN - Marshall® MODE 4 MF350 HEAD -įits only the Marshall® MF350 Mode 4 350W Head. RPM, 18.0 Cubic Feet/Minute Airflow, 27dBA Noise. If your amp has the smaller fan, order the OD5010-12, above. MG50DFX and the MG250DFX used a smaller fan (2" x 2" x 3/8"). Some Marshall® versions of the MG100DFX, MG100HDFX, If the old fan is 2 3/8" x 2 3/8" x 1", this is PREMIUM TYPE (BALL BEARINGS), HIGH AIRFLOW, LOW NOISEįits some versions of the Marshall® MG100DFX, MG100HDFX, MG50DFX and the MG250DFX models. RPM, 11.0 Cubic Feet/Minute Airflow, 26dBA Noise. If your amp has the larger fan, order the OD6025-12, below. MG50DFX and the MG250DFX used a larger fan (2 3/8" x 2 3/8" x 1"). If the old fan is 2" x 2" x 3/8", this is theĬorrect fan. These are the models with the large "MG" on the front panel. NOTE: Does NOT fit the MG50FX, MG100FX, or MG100HFX models. PREMIUM TYPE (BALL BEARINGS), HIGH AIRFLOW, LOWER NOISEįits many of the Marshall® MG100DFX, MG100HDFX, MG50DFX and the MG250DFX models. OUTPUT MODULE FAN - Marshall® MG SERIES AMPS.
0 kommentar(er)
